Control Plan in Simple Terms
The PFMEA identifies what can go wrong in a process. The control plan turns that into daily practice on the shop floor. It is one of the AIAG core tools, a required PPAP element and a living document that changes whenever the process changes.
AIAG publishes a dedicated Control Plan reference manual, and IATF 16949 requires control plans at system, subsystem, component or material level.
Key Elements
- Process step and machine or tool.
- Product and process characteristics, with special characteristics marked.
- Specification and tolerance.
- Evaluation or measurement technique.
- Sample size and frequency.
- Control method, such as SPC, error-proofing or a check sheet.
- Reaction plan if the result is out of tolerance.
Control plans are written for three phases: prototype, pre-launch and production.
Example
For a press-fit bearing operation, the control plan lists press force as a special characteristic, monitored 100 percent by a force sensor that rejects out-of-range parts, and bearing height checked with a dial gauge on 5 parts per hour and charted. The reaction plan says to stop, quarantine parts since the last good check and notify the supervisor.
Common Mistakes
- Writing the control plan separately from the PFMEA, so they do not match.
- Vague reaction plans such as notify quality.
- Not updating it after a CAPA or process change.
The OperaHive FMEA software connects FMEA with control plans and APQP. Our IATF 16949 core tools guide shows how they fit together.