Analytical Method Validation in Simple Terms
Before a lab uses a test, for example an HPLC assay that measures how much active ingredient is in a tablet, it must show the test gives the right answer every time. The main guideline is ICH Q2, which lists the characteristics to check. Regulators such as the FDA and EMA expect validated methods for release and stability testing.
In general manufacturing, the closest idea is measurement system analysis, where a gauge R&R study shows a gauge is good enough for the tolerance.
Key Elements
| Parameter | What it shows |
|---|---|
| Specificity | The method measures the target and not impurities or other ingredients |
| Accuracy | Results are close to the true value |
| Precision | Results agree when repeated, by the same or different analysts and days |
| Linearity and range | Results are proportional to the amount present across the working range |
| Detection and quantitation limits | The lowest amount that can be detected or measured reliably |
| Resistance to small changes | Small changes in conditions do not change the result much |
Example
A lab validating a tablet assay tests spiked samples at 80, 100 and 120 percent of the target strength. Recovery is between 98 and 102 percent, repeat injections agree within 1 percent, and two analysts on different days get matching results, so the method is approved for batch release.
Common Mistakes
- Validating with too few samples or a range narrower than real use.
- Changing the method later without revalidation through change control.
- Using instruments that are out of calibration, which weakens every result.
Method validation itself is a lab activity, but it relies on calibrated equipment. OperaHive calibration management software tracks calibration due dates, certificates and MSA records for that equipment.