Work Instruction in Simple Terms
If a standard operating procedure says what must happen in a process, the work instruction shows exactly how to do one job within it. It is written for the person doing the work, usually at the workstation, and often uses photos, diagrams and short sentences.
Key Elements
- Part number, operation and revision level.
- Tools, gauges, fixtures and materials needed.
- Numbered steps, each with one action.
- Photos of the correct result and of common defects.
- Key and safety points, such as torque values or special characteristics.
- Checks to perform and where to record them.
Work instructions should match the control plan, so the checks operators do are the ones the plan requires.
Example
A work instruction for fitting a door hinge has six steps. Step 4 reads "Torque both M8 bolts to 25 Nm in the order shown" with a photo, and is marked as a key point. Step 6 tells the operator to apply a paint mark to show the torque was checked.
Common Mistakes
- Long paragraphs that operators do not read.
- Old printed copies left at the station after a change.
- Instructions written by engineers without trying them with operators.
Work instructions need the same document control as other quality documents; OperaHive document control software handles revision history, approvals and read acknowledgements.